Get started with MagWLED

Choose the board you have for the right power, wiring and firmware instructions. The model name is printed on the board.

MagWLED-1

MagWLED-1 with its blue PCB and low-profile WAGO connector

The original controller: one LED output, a low-profile WAGO spring connector and an ESP32-C3.

Set up MagWLED-1

MagWLED-2

MagWLED-2 from above, with USB-C on the left and a green screw-terminal block on the right

Two LED outputs, a green screw-terminal block, an ESP32-S3 and a built-in digital microphone.

Set up MagWLED-2

Already set up?

Choose your board · FAQ & troubleshooting · Firmware & updates · Technical documentation

Choosing a controller? Compare MagWLED-1 and MagWLED-2.