Enclosures & CAD

MagWLED-2

A precision-fit, two-part case designed straight from the MagWLED-2's own 3D model. It prints without supports, closes with four M2 screws and keeps everything within reach: USB-C, the BOOT and RST buttons, the status LEDs, the screw terminals and the GPIO header. Optional wall-mount ears let you screw it to any surface.

• Made to fit: built around the board's own CAD model, with the board seated on standoffs and a ledge under its edge.
• Everything reachable: one opening for the USB-C and JST-SH sockets, holes for BOOT and RST, a slot over the power and USB PD LEDs, an open window over the screw terminals and a slot for the GPIO header.
• Cool-running: ventilation slots under the ESP32 and the power section, plus open windows over the terminal block and the header.
• Print-friendly: no supports and no brim. The lid prints roof-down, and its engraved logo and markings are wide enough for a standard 0.4 mm nozzle.
• Mount it your way: choose the base with wall-mount ears for M3 screws, or the compact base without them.

MagWLED-2 enclosure downloads

• MagWLED-2 enclosure lid (STL, already flipped: roof on the print bed)
• MagWLED-2 enclosure base with wall-mount ears (STL, floor on the print bed)
• MagWLED-2 enclosure base without ears (STL, floor on the print bed)

Print the lid and one of the two bases. The case measures 53.7 × 39.7 × 15 mm (74.5 mm wide with the ears).

MagWLED-2 assembly

• Hardware: four M2 × 10 mm countersunk screws from underneath, plus two M3 screws if you use the ears.
• Set the DIP switches before you close the case; they stay inside.
• Reach the BOOT and RST buttons with a paper clip through the two holes on top.
• The USB-C opening takes plug overmolds up to about 12.4 × 6.2 mm.
• The lid closes with a snug push fit and is held by the four screws. Wire the terminals before or after closing: the wires drop into the open slots in the lid's side wall.

MagWLED-1

Many MagWLED-1 users love how easy it is to fit and mount it using the on-board mounting holes. However, sometimes a simple enclosure is what's needed.

MagWLED-1 enclosure downloads

• MagWLED-1 enclosure top (STL)
• MagWLED-1 enclosure bottom (STL)
• MagWLED-1 enclosure STEP

MagWLED-1 community designs

• Enclosure holder for vertical mounting (thanks, Gregory!)
• STL file for enclosure with external button mechanism (thanks, James!)
• Other options on printables.com

If you want to design your own enclosure, you can use this STEP file for the PCB itself:

• MagWLED-1 PCB STEP File